AutoCAD MEP Wishes

Reply
New Member
Posts: 1
Registered: ‎10-06-2012
Message 1 of 1 (1,028 Views)

Counting bends in a conduit run

1028 Views, 0 Replies
10-06-2012 10:02 AM

I  use MEP AutoCad  to 3D model conduit runs. Does MEP have a option that  after I finish modeling a conduit run it would tell me how many degrees I have put into that conduit run.National electrical code requires that no conduit  run have more than 360 dgrees.After that a pull box is required .It would help if as I run the conduit throughout the building ,if I exceed the 360 degrees it would  prompt me that a pull bow is requred.Or another way if after I finish the run I have a option that would add the pull boxes as needed.Any help?

Regards,

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Welcome to the new Autodesk Community!
If this is your first visit, click here to get started and make the most of the Community. Let us know what you think of the new experience in the Community Feedback Forum.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community