AutoCAD MEP Wishes

Reply
Distinguished Contributor
mike.gustus
Posts: 139
Registered: ‎11-18-2007
Message 1 of 1 (390 Views)

Conduit Rack

390 Views, 0 Replies
03-25-2009 11:28 AM
I wish....

That I could create a RACK object and give this rack properties that have all the information about what is on that rack. Size, quantity and order of of conduit, how many levels of conduit are on the rack, separation of conduits. How many tiers of of strut for the rack etc.... and then after all that is configured, be able to BREAK, OFFSET and CONNECT the entire rack with one MEP snap connection and have all the conduits connect properly.

Then have the ability to peel off individual conduits as they need to drop off. Basically treating a conduit rack as a single object.

I am working on a job that has one rack that is 5 levels deep and has about 80 conduits on it. It takes forever to connect each conduit if there is anything other than a straight run.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community