AutoCAD MEP Wishes

Reply
New Member
jdimiele
Posts: 2
Registered: ‎11-23-2010
Message 1 of 1 (648 Views)

Conduit Offsets

648 Views, 0 Replies
11-23-2010 05:07 AM

Is there a way that every offset I create will be a full radius to radius connection instead of putting a piece of straight in-between to smaller radius pieces?  Right now I have to extrude to make that happen and is very time consuming.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you interested in helping shape the Autodesk Community?
We’re looking at a few different ways to improve the “All Forums” landing page and need your feedback! If interested, please take a few minutes to fill out the following Usability Study. Thank you for your time!

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community