AutoCAD MEP Wishes

New Member
Posts: 2
Registered: ‎11-23-2010
Message 1 of 1 (647 Views)

Conduit Offsets

647 Views, 0 Replies
11-23-2010 05:07 AM

Is there a way that every offset I create will be a full radius to radius connection instead of putting a piece of straight in-between to smaller radius pieces?  Right now I have to extrude to make that happen and is very time consuming.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Welcome to the new Autodesk Community!
If this is your first visit, click here to get started and make the most of the Community. Let us know what you think of the new experience in the Community Feedback Forum.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community