AutoCAD MEP Wishes

Posts: 12
Registered: ‎04-18-2008
Message 1 of 1 (970 Views)

Cast Iron Reducing TEE's & 90's

970 Views, 0 Replies
03-01-2011 02:03 PM

This is the biggest no-brainer for improvement......  Since when does a contractor install a straight tee or 90 then a reducing coupling to make up the smaller diameter...  Drawing pipe takes twice as long because of this flaw & three times as long for re-draws.....  Most of the time I erase and start over.   PLEASE FIX THIS!



You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Welcome to the new Autodesk Community!
If this is your first visit, click here to get started and make the most of the Community. Let us know what you think of the new experience in the Community Feedback Forum.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community