AutoCAD MEP Wishes

Reply
Contributor
kenzco
Posts: 12
Registered: ‎04-18-2008
Message 1 of 1 (990 Views)

Cast Iron Reducing TEE's & 90's

990 Views, 0 Replies
03-01-2011 02:03 PM

This is the biggest no-brainer for improvement......  Since when does a contractor install a straight tee or 90 then a reducing coupling to make up the smaller diameter...  Drawing pipe takes twice as long because of this flaw & three times as long for re-draws.....  Most of the time I erase and start over.   PLEASE FIX THIS!

 

Thanks!
     

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community