AutoCAD MEP Wishes

Reply
Active Contributor
Posts: 36
Registered: ‎02-24-2010
Message 1 of 1 (445 Views)

Automatic Piping Unions

445 Views, 0 Replies
02-24-2010 12:51 PM
I've been using MEP since the 2008 version. With the 2010 version, Autodesk decided to include automatic unions. Anytime you join two sections of pipe a union/couplilng is inserted. Also, anytime you extend piping from a plumbing fixture a union/coupling is inserted. This is a serious pain. There is no reason for me to show unions at these locations. I've gone through the AutoCad MEP 2010 manual and it seems like this is built into the system with no setting to turn off. The only way I've found to get around it is by using the Standard routing preference. Please don't include this setting in MEP 2011.

Has anyone had this issue? Any Solutions?

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you interested in helping shape the Autodesk Community?
We’re looking at a few different ways to improve the “All Forums” landing page and need your feedback! If interested, please take a few minutes to fill out the following Usability Study. Thank you for your time!

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community