AutoCAD MEP General

Reply
New Member
walter1959
Posts: 1
Registered: ‎08-23-2012
Message 1 of 2 (286 Views)

duct sizing

286 Views, 1 Replies
08-23-2012 11:00 AM

hi, this might seem like a stupid question but i am just learning hvac on mep 2013 and the duct sizes sometimes come out in half sizes such as 13-1/2". i have set the flow rates on the diffusers and no matter what i try, i can't seem to get it to come out in straight sizes. am i missing a step?

*Expert Elite*
Keith.Brown
Posts: 1,074
Registered: ‎03-13-2008
Message 2 of 2 (279 Views)

Re: duct sizing

08-23-2012 12:48 PM in reply to: walter1959

Sounds like you are using the duct size calculator.  If you are then you can set it to use whole inch increments.  This is done by using the USE CATALOG SIZES dropdown as shown in the picture below and selecting "1 inch increment".

 

Duct Calculator.jpg

 

 


Keith Brown AutoCAD MEP BLOG | RSS Feed
AutoCAD MEP 2014 | Revit 2014 | EastCoast CAD/CAM V6.1 | Visual Studio 2013
────────────────────────────────────
⁞|⁞ Please use Mark Solutions!.Accept as Solution and Give Kudos!Give Kudos as appropriate. Thank you!

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD MEP Category!

The AutoCAD MEP forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community