AutoCAD MEP General

Valued Contributor
Posts: 73
Registered: ‎02-14-2011
Message 1 of 2 (192 Views)


192 Views, 1 Replies
02-05-2013 03:54 AM

Is there a way of turning the insulation off an entire system without going over every piece of pipe?

*Expert Elite*
Posts: 1,074
Registered: ‎03-13-2008
Message 2 of 2 (186 Views)


02-05-2013 05:07 AM in reply to: mjmpe

Yes there is.  Just select one piece of duct from the system and then type SELECTMEPBYSYSTEM.  It will select all duct of the same system.

Keith Brown AutoCAD MEP BLOG | RSS Feed
AutoCAD MEP 2014 | Revit 2014 | EastCoast CAD/CAM V6.1 | Visual Studio 2013
⁞|⁞ Please use Mark Solutions!.Accept as Solution and Give Kudos!Give Kudos as appropriate. Thank you!

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD MEP Category!

The AutoCAD MEP forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community