AutoCAD MEP General

Reply
Active Member
Posts: 9
Registered: ‎12-18-2012
Message 1 of 1 (215 Views)

Isometric Snap

215 Views, 0 Replies
01-07-2013 07:32 AM

Can anyone tell me why when I set my snap to isometric snap and then draw a line, it does not follow the exact isometric angle so my snap is then rendered useless?  The only way I have found to be able to draw things isometrically and still utilize snap is to make sure that ortho and polar are off which makes it very difficult when drawing long isometric lines.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Welcome to the new Autodesk Community!
If this is your first visit, click here to get started and make the most of the Community. Let us know what you think of the new experience in the Community Feedback Forum.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD MEP Category!

The AutoCAD MEP forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community