AutoCAD MEP General

Reply
Contributor
duran492
Posts: 12
Registered: ‎05-13-2011
Message 1 of 2 (212 Views)

HELP! on pasting 1 block to multiple nodes at one time!?!?!

212 Views, 1 Replies
08-17-2012 02:57 PM

i have a block of a hanger point that i created.

 

All the hanger blocks that i created have an X at the top where the strap screws into a deck or stud etc..

 

The X, acts a center point for me to paste my hanger point from it's node and be dead on for layout purposes.

 

 

Is there any way to paste my hanger point to all the X's i have through out the drawing?

 

 i have over 2500 hangers that have an X as the center point of a rod. For me to individually paste each one would seem like it would take an eternity. Im looking for an easier way to paste one node of a block on to the 2500 center points.

 

HELP ahaha!!<!?!?!?!

 

 

Active Member
Posts: 7
Registered: ‎02-18-2009
Message 2 of 2 (192 Views)

Re: HELP! on pasting 1 block to multiple nodes at one time!?!?!

08-20-2012 01:46 PM in reply to: duran492

simple,

 

Is the existing X a block that will only contain the Hanger?

 

simply edit the existing X refference block to inclued the Hanger... this seems to be very east

 

I hope this works for you

 

Regards,

 

 

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you interested in helping shape the Autodesk Community?
We’re looking at a few different ways to improve the “All Forums” landing page and need your feedback! If interested, please take a few minutes to fill out the following Usability Study. Thank you for your time!

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD MEP Category!

The AutoCAD MEP forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community