AutoCAD MEP General

Reply
Valued Contributor
Posts: 69
Registered: ‎12-18-2009
Message 1 of 2 (367 Views)
Accepted Solution

CONVERTING TO MV PART

367 Views, 1 Replies
01-05-2013 10:57 AM

Ok, my brain is not working today. I want to create a block based MVPART. If I remember correctly I need  to draw the unit, then create block and then convert to MVPART.  I have done this before, It has been a while and  I am just missing something this time. I am trying to make a condensing boiler. I make a box from the solids tab. I try to place a circle on the side plane  of the box so i can extrude it to make the inlet and outlet for my piping. It will not allow me to do so. Can someone please tell me what I am forgetting?

Valued Contributor
Posts: 69
Registered: ‎12-18-2009
Message 2 of 2 (365 Views)

Re: CONVERTING TO MV PART

01-05-2013 11:05 AM in reply to: jerry.wms

Found it. "ALLOW/DISALLOW DYNAMIC UCS" was turned to DISALLOW.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Welcome to the new Autodesk Community!
If this is your first visit, click here to get started and make the most of the Community. Let us know what you think of the new experience in the Community Feedback Forum.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD MEP Category!

The AutoCAD MEP forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community