AutoCAD MEP General

Reply
New Member
fouad.issa
Posts: 2
Registered: ‎02-21-2011
Message 1 of 2 (381 Views)

Bottom of Conduit Elevation Dynamic Property Field

381 Views, 1 Replies
06-01-2012 03:04 PM

Hello, Is there a way to add a property field to conduits/pipes that would allow the input of "Bottom of Conduit" value as supposed to the default "Elevation" field that picks the center of conduit?

The intent is that when I select multiple conduits and input an elevation, all conduits will be aligned to the bottom.

 

Thanks in advance!

 

-Fouad

Active Member
timmyt21
Posts: 9
Registered: ‎07-22-2012
Message 2 of 2 (281 Views)

Re: Bottom of Conduit Elevation Dynamic Property Field

10-01-2012 09:58 AM in reply to: fouad.issa

I need this as well. I can't figure anyway to do this. I'm getting really pissed off at Revit. Especially when I'm running racks with 70 conduits on it.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD MEP Category!

The AutoCAD MEP forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community