AutoCAD MEP General

Reply
Valued Contributor
Posts: 67
Registered: ‎12-11-2003
Message 1 of 3 (354 Views)
Accepted Solution

Bevelled duct

354 Views, 2 Replies
09-03-2013 08:26 AM

Is there a way to terminate an open-ended MEP duct with a bevel cut? i.e., for a section of duct connected to an exhaust fan discharge? :smileysad:

Product Support
Posts: 168
Registered: ‎10-01-2009
Message 2 of 3 (333 Views)

Re: Bevelled duct

09-04-2013 01:39 PM in reply to: jcharles2417

There is no way to bevel cut a duct. Your only option would be to create an end cap fitting with the desired geometry and place that at the end of the duct.



David Pothier

*Expert Elite*
Keith.Brown
Posts: 943
Registered: ‎03-13-2008
Message 3 of 3 (255 Views)

Re: Bevelled duct

09-26-2013 10:19 AM in reply to: jcharles2417

Hi JCharles2417,

 

You might look into creating a custom fitting.  You supply a path and need just start the DUCTCUSTOMFITTING command.  I am not sure if you will be able to get the exact look that you are looking for however.


Keith Brown AutoCAD MEP BLOG | RSS Feed
AutoCAD MEP 2014 | Revit 2014 | EastCoast CAD/CAM V6.1 | Visual Studio 2013

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Welcome to the new Autodesk Community!
If this is your first visit, click here to get started and make the most of the Community. Let us know what you think of the new experience in the Community Feedback Forum.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD MEP Category!

The AutoCAD MEP forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community