AutoCAD MEP General

Reply
Contributor
Posts: 11
Registered: ‎12-21-2006
Message 1 of 1 (290 Views)

AMEP 2012 - Standard Conduit Bends?

290 Views, 0 Replies
03-22-2012 07:26 AM

Let's try this again...

 

AutoCAD MEP 2012 has 5 standard bend angles for conduit that it uses when auto-routing a conduit run - 15,30,45,60 & 90 degrees.

 

Does anyone know where these angles are set at?  I would like to add 3 other common bends that aren't listed - 5, 10 & 22.5 degrees.

 

In AMEP 2010 and farther back one could just add them in the conduit dialog box > Use Routing: Elbow Angle and type in the angle - AMEP would remember the angle for future routing.

 

In AMEP 2012 if you try and do something similar in the properties window while routing conduit, one can force the angle (by locking it), but it is not remembered.

 

Thoughts/comments?

 

Any help is greatly appreciated.

 

Scott

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you interested in helping shape the Autodesk Community?
We’re looking at a few different ways to improve the “All Forums” landing page and need your feedback! If interested, please take a few minutes to fill out the following Usability Study. Thank you for your time!

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD MEP Category!

The AutoCAD MEP forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community