AutoCAD MEP General Discussion

Reply
Valued Contributor
mjmpe
Posts: 73
Registered: ‎02-14-2011
Message 1 of 2 (208 Views)

pipe goes single line when I switch systems

208 Views, 1 Replies
01-05-2013 05:17 AM

I started drwg 3"  butt weld pipe, noticed the system was on standard, when I went to switch it to natural gas, the pipe went to single line. How come? what do I need to do?

 

thanks

*Expert Elite*
Keith.Brown
Posts: 1,093
Registered: ‎03-13-2008
Message 2 of 2 (205 Views)

Re: pipe goes single line when I switch systems

01-05-2013 05:25 AM in reply to: mjmpe

Try this link out.

 

Configuring System Definitions for 1-Line, 2-Line, or Single Line Graphics


Keith Brown AutoCAD MEP BLOG | RSS Feed
AutoCAD MEP 2014 | Revit 2014 | EastCoast CAD/CAM V6.1 | Visual Studio 2013
────────────────────────────────────
⁞|⁞ Please use Mark Solutions!.Accept as Solution and Give Kudos!Give Kudos as appropriate. Thank you!

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD MEP Category!

The AutoCAD MEP forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community