AutoCAD MEP General Discussion

Reply
*Andrew
Message 1 of 3 (198 Views)

Tick marks on plumbing fittings

198 Views, 2 Replies
07-07-2003 01:26 AM
Is there a way to get rid of the tick marks on plumbing fittings?
Active Contributor
Buster1379
Posts: 41
Registered: ‎11-08-2003
Message 2 of 3 (198 Views)

Re: Tick marks on plumbing fittings

07-07-2003 03:18 AM in reply to: *Andrew
Andrew,
I believe you can turn off the ticks on plumbing fittings if you go to your plumbing system definitions, then modify the system that this if affected by, then modify the display properties so that the connector is turned off,
hope this helps,

Buster1379
*Andrew
Message 3 of 3 (198 Views)

Re:

07-07-2003 04:36 AM in reply to: *Andrew
Thanks Buster1379.  That's what I was looking
for.


style="PADDING-RIGHT: 0px; PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: #000000 2px solid; MARGIN-RIGHT: 0px">
Andrew,

I believe you can turn off the ticks on plumbing fittings if you go to
your plumbing system definitions, then modify the system that this if affected
by, then modify the display properties so that the connector is turned off,

hope this helps,

Buster1379

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD MEP Category!

The AutoCAD MEP forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community