Single line pipe - break line

[bpark212]

I'm trying to adjust the break distance when (2) single line pipes are crossing each other. The default setting shows up alright in model space, but once I plot the drawings, you can't even tell there is a break. I've spent a couple hours looking through the system definitions, display properties, etc. to no avail. 

Does anyone know if you can adjust this distance? I know how to adjust it with wire, but haven't found away to adjust it for pipe. 

Any help is appreciated, thanks. 

I attached a pic of what I'm describing. 

[bpark212]

EDIT: I should have searched a little harder before I made this post! I found the answer to my question.

Mod you can delete this thread if you'd like.

[Keith.Brown]

It would be better if you supplied your answer so anyone else doing a search for this thread will know what the answer was!

[bpark212 · Accepted solution]

Options > MEP Display Control

Then you can select the offset of a line break. This goes for all parts (pipe, duct, etc.) and can be annotative if desired.