Can you do this to ductwork the same as pipework, and if not why not ;o)? I have seen posts in the past asking for the ability to change from double to single on branches off a 2 line main. Is it possible yet on duct?
I did search but didnt find anything new, only old questions.
Also why dont we have specific version release forums? lots of commands and functionality changes from one release to another so it would be good to be able to search a MEP 2008 forum for answers relating to 2008.
Foth
![Autodesk Design & Make Report](https://forums.autodesk.com/t5/image/serverpage/image-id/1350519iCB55845EBFC43016/image-size/large?v=v2&px=999" "Autodesk Design & Make Report")
