AutoCAD MEP General Discussion

Reply
New Member
Lorenkayenta
Posts: 1
Registered: ‎05-23-2011
Message 1 of 3 (281 Views)

Hangers and Pipe

281 Views, 2 Replies
05-23-2011 01:40 PM

The elevation of the pipe is higher than the unistrut, but when I go to print the unistrut weaves throught the pipe. I want the unistrut not to show when the pipe crosses it.  

Active Contributor
Dumfatnhappy
Posts: 34
Registered: ‎02-07-2006
Message 2 of 3 (279 Views)

Re: Hangers and Pipe

05-23-2011 03:32 PM in reply to: Lorenkayenta

how did you make the hangers?  in order for it to 'behave' in MEP you need to make it an MvPart and it will "hide behind MEP objects

 

 

 

*Expert Elite*
Keith.Brown
Posts: 1,090
Registered: ‎03-13-2008
Message 3 of 3 (249 Views)

Re: Hangers and Pipe

05-25-2011 11:50 AM in reply to: Lorenkayenta

Unfortunately, Autocad MEP doesnt break structural items (including hanger objects) when shown below ductwork or piping.  As the previous poster mentioned, you will have to create MvPart trapeze hangers to get this effect. 


Keith Brown AutoCAD MEP BLOG | RSS Feed
AutoCAD MEP 2014 | Revit 2014 | EastCoast CAD/CAM V6.1 | Visual Studio 2013
────────────────────────────────────
⁞|⁞ Please use Mark Solutions!.Accept as Solution and Give Kudos!Give Kudos as appropriate. Thank you!

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD MEP Category!

The AutoCAD MEP forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community