HELP! on pasting 1 block to multiple nodes at one time!?!?!

[duran492]

i have a block of a hanger point that i created.

All the hanger blocks that i created have an X at the top where the strap screws into a deck or stud etc..

The X, acts a center point for me to paste my hanger point from it's node and be dead on for layout purposes.

Is there any way to paste my hanger point to all the X's i have through out the drawing?

 i have over 2500 hangers that have an X as the center point of a rod. For me to individually paste each one would seem like it would take an eternity. Im looking for an easier way to paste one node of a block on to the 2500 center points.

HELP ahaha!!<!?!?!?!

[petrocelli718]

simple,

Is the existing X a block that will only contain the Hanger?

simply edit the existing X refference block to inclued the Hanger... this seems to be very east

I hope this works for you

Regards,