AutoCAD MEP General Discussion

Reply
Valued Contributor
toddn
Posts: 70
Registered: ‎11-24-2003
Message 1 of 1 (74 Views)

Duct Transitions

74 Views, 0 Replies
08-18-2003 01:46 AM
We manufacture all of our duct transitions to be at a 30 degree angle. What would be the correct equation to enter into the Catalog Editor for this to become the default. I know you can change the transition and then enter the degrees but we want it to add the correct transition automatically.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD MEP Category!

The AutoCAD MEP forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community