AutoCAD MEP General Discussion

Reply
Valued Contributor
jerry.wms
Posts: 69
Registered: ‎12-18-2009
Message 1 of 2 (397 Views)
Accepted Solution

CONVERTING TO MV PART

397 Views, 1 Replies
01-05-2013 10:57 AM

Ok, my brain is not working today. I want to create a block based MVPART. If I remember correctly I need  to draw the unit, then create block and then convert to MVPART.  I have done this before, It has been a while and  I am just missing something this time. I am trying to make a condensing boiler. I make a box from the solids tab. I try to place a circle on the side plane  of the box so i can extrude it to make the inlet and outlet for my piping. It will not allow me to do so. Can someone please tell me what I am forgetting?

Valued Contributor
jerry.wms
Posts: 69
Registered: ‎12-18-2009
Message 2 of 2 (395 Views)

Re: CONVERTING TO MV PART

01-05-2013 11:05 AM in reply to: jerry.wms

Found it. "ALLOW/DISALLOW DYNAMIC UCS" was turned to DISALLOW.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD MEP Category!

The AutoCAD MEP forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community