AutoCAD MEP General Discussion

Reply
Valued Contributor
s.lawrence
Posts: 71
Registered: ‎04-18-2011
Message 1 of 2 (196 Views)

Bottom of Cable Tray Measurement

196 Views, 1 Replies
04-10-2012 09:07 AM

Hi all,

 

Is there a way to automatically label the height to the bottom of the cable tray, as can be done with the ductwork? I've looked in the style manager/label curves and there are cable tray options, but only supplier name is shown as being an option. Is there a way to do this?

 

Whilst on the subject of cable tray, I've had a bit of a whinge before (as have many others) about the cable tray inverting itself and being more difficult than it should be to work with, have any people with 2013 found any differences? I have 2013 ready to install and hopefully this will finally be put to bed....holds breath....

 

Thanks!
Stu

Distinguished Contributor
alan.skipper
Posts: 115
Registered: ‎03-01-2008
Message 2 of 2 (173 Views)

Re: Bottom of Cable Tray Measurement

04-16-2012 01:11 AM in reply to: s.lawrence

Still crap I'm afraid.

 

Alan

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD MEP Category!

The AutoCAD MEP forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community