Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
I created a road alignment using a template and it worked fine. I tried creating a 2nd road alignment using the same template and their are square cuts instead of slopes. Any ideas?
My 1st guess is that the 2nd road is deeper than the 1st, so that you may need to increase the width of your existing ground sections so that the slope you have defined will "catch".
Also check to see that the Slope is set properly, and hasn't reverted to Zero. That's something you can set through the attached method highlighted:
Cross Section Control
![Autodesk Design & Make Report](https://forums.autodesk.com/t5/image/serverpage/image-id/1350519iCB55845EBFC43016/image-size/large?v=v2&px=999" "Autodesk Design & Make Report")