AutoCAD Land Desktop

Reply
New Member
Posts: 1
Registered: ‎05-16-2012
Message 1 of 2 (879 Views)

Land Desktop Development 2i: Splitting a polyline

879 Views, 1 Replies
05-16-2012 07:29 AM

I just joined the site.

I am working on a small water network, 50 miles.

What I have are polylines defining the layout of the network and data points (x,y, z) defining features such as fire hydrants, water valves etc.

I need to split the polylines at the water valves and fire hydrants but I don’t want to do it one by one. Is there a way to tell AutoCad to split a line everywhere where it finds a data point?

Thank you very much for your help.

Member
Posts: 4
Registered: ‎06-08-2012
Message 2 of 2 (849 Views)

Re: Land Desktop Development 2i: Splitting a polyline

06-08-2012 08:12 AM in reply to: themindfuerzainfinita

The only thing I can tell you, is that you can't. You have to break your lines individually, using the break command or change your linetype to dashed, center, phantom so that the line is already broken for you. I can't promise it will go through all your fire hydrants though. Best of luck!

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Welcome to the new Autodesk Community!
If this is your first visit, click here to get started and make the most of the Community. Let us know what you think of the new experience in the Community Feedback Forum.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community