Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
LD 2006, performing volume calculations. I read on a separate post that calculations are given in "cubic yards" - does the program run a calculation assuming the contours are in feet?
The units in our drawing are set to decimal. The volumes seem low - I was wondering if we were to backtrack and cube the "cubic yard" calculation if that would really be the cubic meter calculation? It would make sense if the program is running an automatic "feet to yards" calculation.....
![Autodesk Design & Make Report](https://forums.autodesk.com/t5/image/serverpage/image-id/1350519iCB55845EBFC43016/image-size/large?v=v2&px=999" "Autodesk Design & Make Report")