AutoCAD LT

[#1]

That is the weird part.  I guess it's only my CAD.  I open up the first drawing with the issue and my settings are as shown below (qleader_issue).  The other file that I changed the settings in, shows up with the "always left justify" and "middle of top line" attachment for left and right.

I have a feeling it will not be an issue when I log on with the user I created yesterday for the open folders issue I'm also having.  I'll try that in a minute and post back, but what is my CAD doing differently that would cause this to happen?

[#2]

There are a few possible workarounds for your issue with the Qleader Settings.  You can modify your QLeader settings within your template.dwt file.  This will allow you to move forward and keep your settings for your future files.  In regards to your existing files, the following link will bring you to an additional Forum Discussion.  

http://forums.autodesk.com/t5/AutoCAD-2013/quot-Qleader-quot-Setting-Question/m-p/3441319/highlight/...

The use of a LISP file should allow you to have your desired settings be set when opening an existing drawing.

Regarding the situation with the QLeader settings as a whole, this is an actually known issue and a change request has been logged with our development team.

This is a link to our feed back page (http://usa.autodesk.com/adsk/servlet/index?siteID=123112&id=1109794).  Here you can make suggestions regarding Autodesk Products

If this has resolved your forum request, please check "Accept as Solution".

Regards,

[#3]

Correct me if I'm wrong, but lisp is not supported by AutoCAD LT is it?  I know it was not as of 2009, but I haven't been looking for it in the last few releases.

Thanks,

Lance

[#4]

No Lisp in LT

or Profiles for that matter