AutoCAD LT General

Product Support
Posts: 358
Registered: ‎11-09-2009
Message 11 of 12 (244 Views)

Re: paste issues again!!

11-20-2012 07:25 AM in reply to: EL-Designer

Thank you to everyone engaging in assisting in this post.  One suggestion moving forward would be to perform a total clean up procedure on a test copy of this affected file using the sequence outlined in the link below.  This will then strip out all potential problems and create a new, fresh, cleaned up file for use.  This also works for many other scenarios of corrupted or lagging files.


File clean up:

Michael Bussiere II
Support Specialist
Product Support
Autodesk, Inc.
New Member
Posts: 1
Registered: ‎11-11-2013
Message 12 of 12 (105 Views)

Re: paste issues again!!

11-11-2013 07:07 AM in reply to: MichaelBussiere2
I'm having this same problem.....I have even cut the file into 3 files and it just stops allowing me to paste. I have deleted and reinstalled Autocad LT 2013 as per support. This didn't help either. I also followed this last step as well and it still does the same thing. It will paste once or twice then stop and like the other guy said if it does paste something I've never seen pops up. I've never seen anything like this and it's hard to get a project out with all of this.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community