AutoCAD LT General

Reply
Member
iothomas
Posts: 4
Registered: ‎02-05-2013
Message 1 of 2 (3,781 Views)

Fatal error: unhandled Access violation writing 0x0000 exception at 0h

3781 Views, 1 Replies
02-05-2013 09:33 PM

I have just installed Autocad LT 2013 (licence bought yesterday) on a new Lenovo E330 laptop and the first time I'm trying to run Autocad I'm getting the following error: "fatal error: unhandled Access violation writing 0x0000 exception at 0h". 

 

I have googled a bit around and the most helpful link was the following:

http://forums.autodesk.com/t5/AutoCAD-Civil-3D/quot-Fatal-Error-Unhandled-Access-Violation-Writing-0...

 

I have tried the suggestions on the above posted link:

1. regediting the DWORD Low to all 0000000, but it goes back to whetever value it was (i have tried with changing value and restarting, not restarting... etc. numerous combinations) and the error is still there

 

2. On one ocasion an autodesk employees on that thread informed the user that the generated error report was pointing towards a usb display adapter, and as I was using an external replicator (USB) I decided to try with the laptop running by itself on it's own graphics, that didn't change the error message. Next step update the HD4000 driver to the latest from intel, but still the same fatal error.

 

On top of the above i have also completly unistalled Autocad and all related products, performed new installation with same fatal error again after the installation. I have tried different comatibility modes when running the software and i have tried running as administrator (although I am logged as administrator anyway)

 

ohh and not to forget I have already aplied the service pack before trying any of the above!  and submited numerous error reports that autocad generated.        

 

any help would be apreciated... 

Product Support
Albert_Rius
Posts: 95
Registered: ‎09-27-2011
Message 2 of 2 (3,750 Views)

Re: Fatal error: unhandled Access violation writing 0x0000 exception at 0h

02-06-2013 02:36 AM in reply to: iothomas

 

Hi,

 

Please can you try to install, running Windows in diagnostic mode?

 

http://usa.autodesk.com/getdoc/id=TS75218

 

The solution is applicable for all products and Windows versions.


______________________________________________________________

If my post answers your question, please click the "Accept as Solution" button. This helps everyone find answers more quickly!

 

 



Albert Rius
Frontline Technical Support
Autodesk, Inc.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community