Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
Spline curve command has changed. This is terrible as I used to use simple line types to show different things on my drawings that was rapid fast with custom macros etc. Now the spline curve command does not work in same way costing me hours of time wasted. I have now resorted in saving all incoming drawings to older version and completing my drawings that way. Only problem is the new drawings are growing above the capabilities of my old machine.
How can I initiate the old std 2 point spline curve in the new software so it works the same way as old version?
The way the 2 point spline command works has changed somewhere between LT 2007 & LT 2012. Not sure exactly when. On 2007 you can select 1st point, 2nd point, direction of 1st point then direction of second point. I cannot get it to work the same in LT 2012. I use this to insert a flexible duct line type between 2 points but get strange results in LT 2012. Any advice welcome..
Check method - it should be "Fit", then pick first point, than "start Tangency" option - pick point you need, than pick end point of spline, then "end Tangency" option:
Maxim
Do you find the posts helpful? "LIKE" these posts! Have your question been answered successfully? Click 'ACCEPT SOLUTION' button.