Hello, I am having an issue with autocad 2012 LT. When my users try and plot a length greater than 250 inches it will plot almost half of the drawing then it would act like it is finished, go into the drying mode and cut the paper. It will do everything under 250 fine.
Computers being used are Windows 7 64bit machines and plotter is a HP Designjet z6100.
I have tried different drivers, different settings within autocad. I am just not sure if it is a limitation of LT or if I am missing something since I am not a autocad expert.
Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register
Start with some of our most frequented solutions to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!