AutoCAD Electrical

[#1]

Hello all.  Not sure if anyone else has had this happen, but when I am in the temrinal editor and I insert my end barriers, end anchors, jumpers, etc, I will exit out to do something else.  But when I come back into it (either next day, or later the same day) all the changes will be gone.  And yes, afetr exiting the editor, the program will go through and do a bunch of updating to other pages as needed.

It is getting really annoying having to repeat all that work, epsecialyl when I have several TB strips that need this editing.

Any help or suggestions would be appreciated.

Thanks

Doug

[#2]

They either go missing for me or all end up at the bottom of the list and I have to re-arrange everything.

That's why I don't do the terminal stip layouts until the schematics have been approved and are ready to issue.

Regards Brad

[#3]

Do you have the graphical terminakl strip inserted on any page?

All this extra information for a terminal strip is saved in the graphical terminal strip, and not in the schematic terminals.

[#4]

Pretty sure rhesusminus is right. Try placing the strip off to the side somewhere until your ready to use it in the panel. At that point you can insert again and place it as needed.