AutoCAD Electrical
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic to the Top
- Bookmark
- Subscribe
- Printer Friendly Page
*Ed
Signal Arrow Style
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
99 Views, 2 Replies
04-13-2004 12:39 PM
How do I remove just the text 'From' or 'To' on the source-destination
cross-reference and make it the default.
That is, I select '1' on the Signal Arrow Style dialog box, but I do not
want the text 'To' on the drawing (I do want the wire #).
--
Ed
*Nate Holt \(Autodesk\)
Re: Signal Arrow Style
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
04-13-2004 09:49 PM in reply to:
*Ed
Ed,
The "to" and "from" text is pulled from the XREF attribute's "prompt" value.
To get rid of it, open up each of the signal arrow library symbols (ex:
HA1S1.dwg in your JIC1 or JIC125 or IEC2 or IEC4 folder - whichever library
you're using), and use DDEDIT to edit the XREF attribute definition. Blank
out the "prompt" value in the edit box. Do this to each of the arrow symbols
(there are 8 per "style"). That should do it.
Nate.
"Ed" wrote in message
news:407c420e_3@newsprd01...
> How do I remove just the text 'From' or 'To' on the source-destination
> cross-reference and make it the default.
> That is, I select '1' on the Signal Arrow Style dialog box, but I do not
> want the text 'To' on the drawing (I do want the wire #).
>
> --
> Ed
>
>
*Ed
Re: Signal Arrow Style
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
04-14-2004 05:49 AM in reply to:
*Ed
Thanks, that did it!
ed
"Nate Holt (Autodesk)" wrote in message
news:407cc2f9_1@newsprd01...
> Ed,
> The "to" and "from" text is pulled from the XREF attribute's "prompt"
value.
> To get rid of it, open up each of the signal arrow library symbols (ex:
> HA1S1.dwg in your JIC1 or JIC125 or IEC2 or IEC4 folder - whichever
library
> you're using), and use DDEDIT to edit the XREF attribute definition. Blank
> out the "prompt" value in the edit box. Do this to each of the arrow
symbols
> (there are 8 per "style"). That should do it.
> Nate.
>
>
> "Ed" wrote in message
> news:407c420e_3@newsprd01...
> > How do I remove just the text 'From' or 'To' on the source-destination
> > cross-reference and make it the default.
> > That is, I select '1' on the Signal Arrow Style dialog box, but I do not
> > want the text 'To' on the drawing (I do want the wire #).
> >
> > --
> > Ed
> >
> >
>
>
