Okay, I see that now! I didn't even know this tool existed. I think that with this combined with placing the block in a smart fashion will be a good solution.
Thank you so much!
Sr. Mfg. Engineer
Just curious if you finalized how you did things. I use the same 4connection terminals, and I have them set up as 4 level terminals (should i set them as 2level though?), and when working on a schematic drawing, I just have to be aware of the need to place a terminal every 4th connection on an I/O bus. I haven't been able to figure out how to make use of the wire connection sequence tool though.