AutoCAD Electrical

[#1]

Currently when I place a wire gauge and color it is displayed above the wire. I would like to have it automatically displayed under the wire. Is their a place to change this? I find it time consuming and a pain to have to move every single wire label. I am using AutoCAD Electrical 2013. Any suggestions would be helpful.

Thank You,

Geoff

[#2]

Hi,

I use the Flip Wire Number command. But not sure if there is any setting to change to skip this step.

Schematic tab> Edit Wires/Wire Numbers panel> Flip Wire Number.

[#3]

Spoiler

Spoiler

Thank you, that works very nicely.