AutoCAD Electrical

[#1]

When I pick an item from the icon menu for insert, it gives the error of file not found, and list all the folders it looks into. But none of these is the Hyd-iso125 folder. So how do I add the search path to include this folder?

Thanks
Eric

[#2 · Accepted solution]

Eric, if you are using AcadE 2007 you right click on the project name and
pick Properties. Under the Project Settings tab you add this path to the
Schematic Libraries. If you are using Acade 2006 then you right click on the
project name and select Symbol Libraries and add it under the Schematic
libraries section.

You can add any paths under these. They will be searched in the order
listed.

Pat Murnen

wrote in message news:5210885@discussion.autodesk.com...
When I pick an item from the icon menu for insert, it gives the error of
file not found, and list all the folders it looks into. But none of these
is the Hyd-iso125 folder. So how do I add the search path to include this
folder?

Thanks
Eric

[#3]

That did it Thank you very much. For I was in a holding pattern. Thanks Again

Hey why is everything inserted in vertical position and offering the rotation opption.

Eric Message was edited by: MTE Controls

[#4]

If I understand your question - the default orientation of the symbol is
based on the drawing ladder property. If the default ladder orientation is
Vertical then the default symbol orientation is Horizontal. It does check
for underlying wires but not until after you select the location. You can
check the box on the Icon menu to first try the other orientation and it
will be remembered but only for that acad session.

Pat Murnen

wrote in message news:5210975@discussion.autodesk.com...
That did it Thank you very much. For I was in a holding pattern. Thanks
Again

Hey why is everything inserted in vertical position and offering the
rotation opption.

Eric

Message was edited by: MTE Controls

[#5]

Thanks, I found out by going to the new demo and studied it for a bit.

Thanks
Eric