AutoCAD Electrical

[#1]

I think I know the answer to this, but I am going to keep my fingers crossed just the same.

I would like to know (hope for on wish list) if when we generate the BOM (or update) we can have this update the BOM we currently have on the drawing. This would be so nice, so that I don't have to keep erasing it and then updating it.

If anyone knows an easy work around, that would be most helpful.

Thanks,

Mike Gaccioli
Prim Hall Ent.

[#2]

Not now, but was told it will be that way in ACE2005 - Due out next week.

Chad

[#3]

You're kidding right?

That will be such a good upgrade.

Thanks,

[#4]

Hi Mike, Today, there isn't another way to handle this without deleting the existing table. We have had this request from other customers as well and we are researching it for a future release of AutoCAD Electrical. Thanks for your input. Regards, Scott Reese AutoCAD Electrical Product Manager Autodesk, Inc. -------------------- "mgaccioli" wrote in message news:30048291.1079463361331.JavaMail.jive@jiveforum1.autodesk.com... > I think I know the answer to this, but I am going to keep my fingers crossed just the same. > > I would like to know (hope for on wish list) if when we generate the BOM (or update) we can have this update the BOM we currently have on the drawing. This would be so nice, so that I don't have to keep erasing it and then updating it. > > If anyone knows an easy work around, that would be most helpful. > > Thanks, > > Mike Gaccioli > Prim Hall Ent.