AutoCAD Electrical

[#1]

Hi,

In Circuit Builder using marker block How to assign wire colour & wire Guage for specific size of the motor Power circuit & Nested Circuit(Control Circuit).

[#2]

The Wire Color and Gauge is derived from the wire layer. This is assigned by creating a Code (like WT01) that has something like this in the command list.

(c:ace_cb_set_wiretype #data 1 0 "_WIRETYPE=BU_1.0MM^2")

Now when you place the marker block on the wire in circuit builder, during the build that wire will be moved to the layer that is stored in WIRETYPE.

[#3]

Hi,

Thank you for your reply.

In nested circuit(control circuit) i am not able to insert WHT_10AWG guage wire after overload NC & LTE-10 light. Red_8AWG guage wire run in total nested circuit.
Please help me how to reslove this issue.

Attached dwg & spread sheet.In spread sheet-sheet name:3ph_H custome(Highlite in Red colour)

[#4]

Hi,

Thank you for your reply.

Ignore Previous mail.

In nested circuit(control circuit) i am not able to insert WHT_10AWG guage wire after overload NC & LTE-10 light. Red_8AWG guage wire run in total nested circuit.
Please help me how to reslove this issue.

Attached dwg & spread sheet.In spread sheet-sheet name:3ph_H custome(Highlite in Red colour)

[#5]

Hi,

Thank you for your reply.

Ignore Previous mail.

In nested circuit(control circuit) i am not able to insert WHT_10AWG guage wire after overload NC & LTE-10 light. Red_8AWG guage wire run in total nested circuit.
Please help me how to reslove this issue.

Attached dwg & spread sheet.In spread sheet-sheet name:3ph_H custome(Highlite in Red colour)