AutoCAD Electrical General

Reply
Distinguished Contributor
iomaxx
Posts: 178
Registered: ‎03-03-2006
Message 1 of 1 (121 Views)

wire numbers not hiding on terminal network

121 Views, 0 Replies
02-26-2013 06:25 AM

I read that wire numbers that are connected to terminals with a WIRENO attribute shown would automatically hide the wire number, so you don't have cluttered drawings with a wire number directly next to a terminal with the wire number. This hasn't been the case, any thoughts where there might be a setting, etc. that i should change?

 

from the ACADE2012 wikihelp page:

AutoCAD Electrical automatically hides wire numbers when the wire number is on the same network as a terminal symbol that carries a copy of the wire number (WIRENO attribute).

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community