AutoCAD Electrical General Discussion

Reply
Contributor
mikegoutier
Posts: 15
Registered: ‎05-20-2012
Message 1 of 2 (135 Views)

wire numbers from inline to ontop of line

135 Views, 1 Replies
10-01-2012 12:49 PM

I am using an old drawing schematic that used inline wire numbers and our new SOP states we need to use ontop of wire wire numbers. I have changed the project (wdp) settings to ontop and updated to the project defauts on the drawing level. Than is i use the command AEIWRENO it wont change them from inline to ontop.

any ideas?

Contributor
mikegoutier
Posts: 15
Registered: ‎05-20-2012
Message 2 of 2 (129 Views)

Re: wire numbers from inline to ontop of line

10-01-2012 01:21 PM in reply to: mikegoutier

part 2 of this question is then i want my wire color and gauge to be below the wire in the center under the wire number by using the command aewirecolorlabel it doesnt seem to allow me to have that control.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community