AutoCAD Electrical General

Reply
Valued Contributor
Utchat
Posts: 73
Registered: ‎03-06-2007
Message 1 of 2 (1,180 Views)

sensor symbols

1180 Views, 1 Replies
09-22-2009 03:10 AM
guys,

In our company we design control panels ranging from lv distribution systems to full blow bems systems.

At the moment i'm designing a full blown bems control system using IEC library as my default (IEC2), are there any iec symbols for sensors (say NTC 10K3A1 or NTC20kohm)?

I also have the same problem for modulating 3 port heating valves.
Kind regards,
Johnny Battiste
*Expert Elite*
dougmcalexander
Posts: 3,001
Registered: ‎10-18-2003
Message 2 of 2 (1,180 Views)

Re: sensor symbols

09-22-2009 07:52 AM in reply to: Utchat
Here are a couple of Pt100 symbols I use; one vertical and one horizontal. These are sized for the IEC2 library. The default RATING1 attribute value is Pt100 but this can be changed to fit your needs.

The main difference in this symbol and the built-in Variable Resistor 2 that ships with AcadE is the B for the default TAG1 attribute value, the removal of the arrow, and the addition of the qualifying symbol for RTD.
Doug McAlexander
Independent Consultant/Instructor/Mentor specializing in AutoCAD Electrical, ecscad, and promis-e implementation

Web site: www.ECADConsultant.com
Phone: (770) 841-8009

Please Accept as Solution if I helped you. Kudos are also much appreciated.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community