AutoCAD Electrical General Discussion

Reply
*dns
Message 1 of 2 (271 Views)

rotate components

271 Views, 1 Replies
04-27-2004 11:20 AM
when i try to rotate a default blocks 180deg, then move it, it rotates back to default. is there a way to bypass this short of drawing a new block? i'm trying to insert a dual tapped transformer. by default the high side is dual tapped , but i would like the low side dual tapped 120/240, so i would just rotate the entire block, then rotate the individual attributes thru the acade tool. but when i scoot the component, everything reverts back to orginal.
Active Member
DougB
Posts: 8
Registered: ‎04-28-2004
Message 2 of 2 (271 Views)

Re: rotate components

04-28-2004 08:31 AM in reply to: *dns
we created multiple blocks to handle this problem
just so we don't have to rearrange the attributes

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community