AutoCAD Electrical General Discussion

Reply
Active Contributor
Rob.y
Posts: 28
Registered: ‎07-06-2005
Message 1 of 3 (106 Views)

"Unable to Load" Message

106 Views, 2 Replies
07-24-2006 08:23 AM
I've recently started getting this message
"**Express Tools** - Unable to load aceauto.lsp/fas no function definition: ACET-HELP-TRAP"
I am using 2006 Electrical. I think it happens when I "Reorder" the drawings in the project, then click "sort" to put them in order.
I have also noticed something changed with my AutoCAD Electrical that it will only let me have one drawing open at a time. I cannot open multiple drawings. Why did this change and start doing this?

Any help would be great.

Thanks.
*Nate Holt \(Autodesk\)
Message 2 of 3 (106 Views)

Re: "Unable to Load" Message

07-24-2006 08:32 AM in reply to: Rob.y
Answer to just one of your questions... the "only one drawing at a time"
one. Type SDI at your command line. It is probably set to 1. Change it to a
0. This will put your system into "Multiple Document" mode.

wrote in message news:5246192@discussion.autodesk.com...
I've recently started getting this message
"**Express Tools** - Unable to load aceauto.lsp/fas no function definition:
ACET-HELP-TRAP"
I am using 2006 Electrical. I think it happens when I "Reorder" the
drawings in the project, then click "sort" to put them in order.
I have also noticed something changed with my AutoCAD Electrical that it
will only let me have one drawing open at a time. I cannot open multiple
drawings. Why did this change and start doing this?

Any help would be great.

Thanks.
Active Contributor
Rob.y
Posts: 28
Registered: ‎07-06-2005
Message 3 of 3 (106 Views)

Re: "Unable to Load" Message

09-08-2006 07:12 AM in reply to: Rob.y
Well, I can no longer check the SDI type. We have upgraded to 2007 and I have had no problems.

I discovered why my other problem occurred. Under Tool, option, system tab and general option, the single drawing compatibility mode was selected. I am not sure why this changed? I am the only using this computer and have been using it for about a year before this started happening. I did unselect it and it fixed that problem.

Sorry for the delay in my reply.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community