AutoCAD Electrical General Discussion

*Expert Elite*
Posts: 1,078
Registered: ‎03-09-2004
Message 11 of 11 (108 Views)

Re: new terminals for terminal block layout

01-18-2013 08:52 AM in reply to: mikegoutier

That depends.


For the schematic symbol, just open up the symbol drawing, edit it and use Swap/Block Update to update it for all the drawings in the project.


For the panel symbol, most ACE symbols do not have the attributes stored in them. You will need to add them to the symbol yourself if you want them in a specific location. ACE uses the wd_ptag*.dwg files to add the attributes to each footprint upon insertion.


I tend to just add the attributes that I want to be on each footprint because I do not like the default locations.




Bob Hanrahan
Ace User since 1998

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community