AutoCAD Electrical General Discussion

Reply
New Member
bruen
Posts: 2
Registered: ‎03-29-2004
Message 1 of 3 (72 Views)

marker fan in/out source or dest

72 Views, 2 Replies
03-29-2004 06:23 PM
I been trying to figure out how to use this feature with little success. I been putting in the source and destination points with little trouble. The problem really happens when putting in the wires going into the multi-conductor cable. If I use the regular wire tool it wants to put in a connection point.
New Member
rneal
Posts: 1
Registered: ‎03-31-2004
Message 2 of 3 (72 Views)

Re: marker fan in/out source or dest

03-31-2004 10:17 AM in reply to: bruen
I aslo have had this same problem. Let me know if you come up with anything. I will do the same
Contributor
Jim Card
Posts: 16
Registered: ‎03-09-2004
Message 3 of 3 (72 Views)

Re: marker fan in/out source or dest

03-31-2004 10:52 AM in reply to: bruen
I have only used this tool on a couple of projects and here is what I have found about how it works. You have to use the AutoCAD LINE command to begin your "wire" fan in/out geometry, up to the point where the fan in/out wires would be horizontal or vertical to connect to your device. Use the Wire Tool for completing the circuit wiring to the device.
Now insert your fan in/out Source & Destination symbols. Then use the Markers - Fan in/out - Layers Toolbutton to assign the basic geometry to the "_MULTI_Layer" layer.
This is how it has worked best for me. A lot of steps but it works. Maybe the pros with speak up and give us some clues. Hope that helped.

Jim
Mckee Foods Corp.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community