AutoCAD Electrical General Discussion

New Member
Posts: 1
Registered: ‎09-14-2012
Message 1 of 1 (77 Views)

insert panel enclosures?

77 Views, 0 Replies
09-14-2012 07:49 AM

i deal with a wide variety of enclosures and subpanels and was just wondering if there is a way of inserting a block w/o having to manipulate an enclosure and save it on my comp say from the Hoffman website. any input would be greatly appreciated.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community