AutoCAD Electrical General

Reply
New Member
Posts: 1
Registered: ‎12-19-2012
Message 1 of 2 (190 Views)

Xref Multiple child and parent

190 Views, 1 Replies
12-19-2012 06:00 AM

Hi, I got a parent symbol with multiple child of the same symbol on different page. The Parent's Xref showing every child location, but the Child's Xref or only pointing at parents, and not at other child. Is there a way to make it appear every other child Xref ?

Thanks,

Sims
Sorry for my bad English !

*Expert Elite*
Posts: 867
Registered: ‎06-01-2010
Message 2 of 2 (177 Views)

Re: Xref Multiple child and parent

12-19-2012 03:20 PM in reply to: sims_69

As far as I'm aware, the industry standard is to have the child block point to the parent block only. I haven't seem ANY standard ask for each child contact to have a full list of other child contacts.

 

This is due to the parent (usually a coil or something similar) normally being located in a fairly open area of the dwg while the contacts and such may be in a congested area of the dwg and not have room for a list of contacts underneath the child component.

 

To place the full cross reference list with each contact would take up a lot of room on the dwg and drafters would have to have huge gaps between components, rungs and anything else to accomadate the cross referencing.

 

Regards Brad

Icemanau (NNTP handle: Brad Coleman)


You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community