AutoCAD Electrical General

Reply
Active Member
Nitro
Posts: 9
Registered: ‎04-08-2004
Message 1 of 5 (125 Views)

Wire Diagram w/Splice

125 Views, 4 Replies
04-19-2004 12:15 PM
How in the world can I create a symbol for a 6 wire open ended crimp on splice like AMP's M81824/1-3 and still utilize the "From To list" and Inv Pro functionality? I need to end up with an accurate BOM and flat cable drawing when Inv Pro is up-dated.
Active Member
DougB
Posts: 8
Registered: ‎04-28-2004
Message 2 of 5 (125 Views)

Re: Wire Diagram w/Splice

04-29-2004 06:59 AM in reply to: Nitro
I'M NOT SURE IF THIS IS WHAT YOU WANT OR NOT.......
BUT HERE YOU GO...
*Expert Elite*
testsubject
Posts: 1,072
Registered: ‎03-09-2004
Message 3 of 5 (125 Views)

Re: Wire Diagram w/Splice

04-29-2004 10:31 AM in reply to: Nitro
What version did you save this at? I could not open it with 2002.
Bob Hanrahan
Ace User since 1998
Active Member
DougB
Posts: 8
Registered: ‎04-28-2004
Message 4 of 5 (125 Views)

Re: Wire Diagram w/Splice

04-29-2004 10:48 AM in reply to: Nitro
sorry

I have been demoing 2005
I'll resubmit as 2000
Active Member
DougB
Posts: 8
Registered: ‎04-28-2004
Message 5 of 5 (125 Views)

Re: Wire Diagram w/Splice

04-29-2004 10:59 AM in reply to: Nitro
here you go

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community