AutoCAD Electrical General

Reply
Distinguished Contributor
Justin2012
Posts: 221
Registered: ‎01-25-2012
Message 1 of 3 (267 Views)

WD_MLRH & Spreadsheet

267 Views, 2 Replies
10-09-2012 01:06 PM

Does anyone knows how I can change the height and width factor for a line  reference? I tried the environmental file but no luck. How does ACE knows where to pick from the library?

 

Also, is there a link somewhere on how to use spreadsheet to build a symbol?

 

Thanks for all the help.

Justin

Distinguished Contributor
Justin2012
Posts: 221
Registered: ‎01-25-2012
Message 2 of 3 (246 Views)

Re: WD_MLRH & Spreadsheet

10-11-2012 05:24 AM in reply to: Justin2012

Please for any answer or guide for the above question....

 

Thanks 

Distinguished Contributor
Justin2012
Posts: 221
Registered: ‎01-25-2012
Message 3 of 3 (154 Views)

Re: WD_MLRH & Spreadsheet

11-29-2012 10:28 AM in reply to: Justin2012

I haven't receive any guide on the above question. Excuse me if it is an easy question; I will appreciate any link or help on how to understand this two workflow.

 

Thanks for reading... 

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community